
8 ways to easily install a bathroom shower, plus tips for caring for your bathroom shower
You want to know how to install a bathroom shower right? Come, see the explanation in this article, so that you do not face trouble when installing the wall shower .
More modern minimalist homes use a shower , because it is considered more comfortable to clean themselves.
In addition to using a shower , showering is a way to save more water than regular showering.
Especially with the different shapes of the shower faucet, of course, it will make the bathroom look simple and aesthetically pleasing.
However, you have to pay attention to how to install the hot and cold water shower of course so that it works properly.
Then how to install shower toilet?
How to install the right bathroom shower
1. Prepare the water pipe
The first step to install a bathroom shower is to prepare the pipe for the water line.
The size of the pipe needed to create a water stream will of course vary depending on the installation in the bathroom.
2. Install the water faucet
In addition to installing pipes, you should also equip wall shower faucets, specifically there is a water faucet section.
If the bathroom is equipped with water heating facilities, you should prepare special taps for hot water and cold water.
This is done so that you will be more comfortable when using the shower set in the bathroom.
3. Install the faucet stop
The next step is to install two stations of hot and cold water faucets, positioned close to the wall shower .
Use a metal faucet for hot water and a plastic faucet for cold water.
4. Install the shower pipe
How to install the next bathroom shower is to install a flexible pipe measuring 25 cm - 30 cm.
Also install 12-inch iron pipe with nipples at the ends.
5. Use soldering tape
Next, apply seal tape to each section of the thread or groove of the faucet.
Continue, by installing the cold and hot tap stops onto the screw plug. Make sure the connection doesn't leak!
6. Install the T-tube.
Next, install the T-iron pipe onto one of the faucet stops. Make sure the tube fitting is tight and does not leak or leak.
7. Connect the flexible tubing
Next method, connect the flexible tube to the end of the faucet stop and tighten the nipples using a wrench.
8. Install the shower hose
Finally, install the hose, and also install the hanger on the bathroom wall.
So, the bathroom wall shower in your home is ready for use.
Bathroom shower care tips
After understanding how to install it, you of course have to know how to care for it.
1. Clean the outside of the shower
a. Dry the still wet shower with a soft cloth so the surface does not peel.
B. This is followed by applying a special cleaning liquid to protect the chrome layer on the shower surface.
C. After applying the cleaning liquid evenly, scrub the surface until it is clean and shiny.
2. Cleaning inside the bathroom
Typically, with use, the shower interior will clog with dirt from the iron content in the water.
This causes, the water drain in the shower becomes clogged, so it must be cleaned carefully.
a. Open the flexible hose by rotating it in different directions.
B. After that, continue washing the clogged filter. Usually, this filter is between the flexible hose and the hand shower .
C. For the hand shower part, clean the shower hole until it is clean.
If you want to read articles similar to the article on how to benefit from air conditioning water
Follow us on the Jaafar Shop blog
اترك تعليق او سؤال